NL Time functions
3. Before the start again on the field s tip. The display
shows the end in focus in white.
4. Set the end time to a later time with the control
ring.
Set kitchen timer
The alarm clock runs in parallel with the other settings.
You can set it at any time, even when the device is
switched off. He has his own signal. This way you will
hear whether the alarm clock or a time has expired.
Set up
The alarm time always starts at zero minutes.
The higher the value, the larger the time steps
become when setting.
You can set up to 24 hours.
1. Tip on the field t.
The symbol is illuminated in red. The alarm time is
highlighted in white on the display.
2. Set the alarm time with the control ring.
3. with field t start.
After a few seconds, the value is accepted, or again
on the field s tip. The display shows the end time
under Function and
Temperature or Stand.
5. Start with the start/stop button l.
The display shows the time at which the appliance
starts.
Note: The alarm will also start automatically after
a few seconds.
The alarm time is running out.
The alarm clock remains visible on the display when the
device is switched off: When the device is in operation,
the settings of the active function are in the
foreground. When you are on the fieldt the alarm time
is displayed for a few seconds.
When the alarm time has ended, a signal sounds and a
message appears on the display. The symbol is no
longer illuminated.
Tip: If the set alarm time applies to the running time of
the device, use the duration. The time is visible in the
foreground and the device turns off automatically.
The device is on hold. When the appliance starts, the
time will count down in the display.
Change and abort
A signal sounds when the cooking time has
ended. The appliance no longer heats up. The
display shows the time 00m 00s.
To change the alarm time, tap the field t. The alarm time
is highlighted in white and can be changed with the
control ring.
You can use the field s set a cooking time again or use
the start/stop button l continue operation without any
time.
If you want to cancel the alarm time, set the alarm time
all the way back. When the change has been adopted,
the symbol is no longer illuminated.
When the dish is ready, switch the appliance off with
the on/off button ÿ from.
Change and abort
To change the end time, first interrupt the operation
with the start/stop button l and tap the field twice s. The
end time is in focus in white and can be changed with
the control ring. With the start/stop buttonl continue
operation.
If you want to delete the end time, set the end time all
the way back. With the start/stop buttonl you can start
the set time immediately.
Note: The end time can only be changed as long as
the duration has not yet expired. It
the cooking result would then no longer be correct.
18
To Next Page
Loading...
