Time functions NL
OTime functions
After a few seconds the value is accepted, or twice
on field s tip. The display shows the duration under
Function and Temperature or Mode.
4. Start with the start/stop button l.
The time counts down on the display.
Ti j df unc ti esYour device has several time functions.
Timekeeping Usage
q Length of time Operation ends automatically after a set
time has elapsed.
r End Enter a duration and a desired end time.
The device starts automatically, so that the
operation ends at the desired time.
t kitchen timer The kitchen timer functions like an egg timer.
It runs independently of the operation of the
device and other time functions. After the set
time has elapsed, the device does not switch
on or off automatically.
You can set the duration and end after setting a
function via the field s to call to action. The kitchen
timer has its own fieldt and can be set at any time.
The appliance starts to heat up.
A signal sounds when the cooking time has
ended. The appliance no longer heats up. The
display shows the time 00m 00s.
A signal sounds at the end of a cooking time or alarm
time. You can end the signal early by pressing thes to
tip.
You can use the field s set a cooking time again or use
the start/stop button l continue operation without any
time.
Note: In the basic settings you can set how long a
signal sounds. ~"
Basic settings" on page 19
When the dish is ready, switch the appliance off with
the on/off button ÿ from.
Change and abort
Set duration
To change the duration, tap the field s. The duration is
highlighted in white and can be changed with the
control ring. With the fields adopt the change.
You can set the cooking time for your dish on the
appliance. In this way, the cooking time is not
unintentionally exceeded and you do not have to
interrupt other work to end use.
If you want to abort the time, set it all the way back
to zero. After the change has been adopted, you can
continue the operation with the start/stop buttonl
continue without time.
Set up
Depending on which direction you first turn the control
ring, the time starts at a suggested value: left 10
minutes, right 30 minutes.
Set end
You can set the time at which the time expires to a later
time. For example, you can place the food in the cooking
compartment in the morning and set it so that it is ready
in the afternoon.
The duration can be set up to an hour in minute
increments, then in 5 minute increments.
You can set a maximum of 23 hours and 59 minutes.
Example in the picture: duration 45 minutes.
1. Set function and temperature or setting.
2. Tip for the start on the field s.
The display shows the duration in white in the focus.
3. Set the cooking time with the control ring.
Clues
■ Make sure that food does not remain in the cooking
compartment for too long and that it does not spoil.
■ Do not set an end if the operation has already
started. The cooking result would then no longer be
correct.
Set up
The end of the time can be delayed up to 23 hours and
59 minutes.
Example in the picture: The set time is 45 minutes and
the dish must be ready at 12:00.
1. Set function and temperature or setting.
2. Set duration.
17
To Next Page
Loading...
