Bosch CRC200 - 8 Service Menu

6 720 821 651 (2017/05) CRC200
16 | Service menu
8 Service menu
▶ If the standard display is active, press and hold the menu
button for about three seconds until the service menu
appears in the main menu.
▶ Press the dial to open the already highlighted service
menu .
▶ Turn the dial to select a menu item or change the value of a
setting.
▶ Press the dial to open the selected menu item, activate the
input field for a setting or confirm a setting.
Fig. 12 Overview of the service menu
1) Available only on the user interface for heating zone 1.
2) Available if supported by heat source.
Main Menu PID charact. Room Temp.
Service Opt. pump run DHW Operation
System Data Room influence Set DHW Temp
HC assignment Contin. heat
DHW Temp.
Auto-Config. Frost protect Maintenance
Pump conn.
1)
Frost thresh. Maint.message
1)
Heat. System DHW Priority Maint. date
1)
Control type Function Test Reset Maint.
1)
Ext.RoomSens. Activation Current Fault
DHW
2)
System pump Fault History
LLH Sensor
1)
HC Pump Clear Fault
Recirculation
1)
Info System info
Solar module Outdoor Temp. Install.date
WWSD
1)
Appl. oper. Control unit
Min.outs.temp Appl.set sply Control SW
Damping Appl.act.sply SW controller
Building Type
Appl.max.sply HC Module SW
Reset All LLH Temp.
Heating circ. HC Operation
Design Temp. HC set.sply
Base line HC act. sply.
Base point
Set Room Temp
Max. Suppl.T.
6 720 821 651-18.2O