6 720 821 652 (2017/05)CRC200
Getting started | 7
4 Getting started
An overview of the structure of the main menu and the position
of the individual menu items can be found on page 11.
Each of the following descriptions takes the standard display as
its starting point ( page 6, Fig. 2 at left).
4.1 Changing the room temperature
Operation Result
To check the current required room temperature.
Auto mode
If the automatic mode is active ( displayed):
▶ Press the auto key.
The desired room temperature then appears on the display for a few seconds. How
long the current setting applies (time to next switching time) appears next for a few
seconds.
Manual operation
If the hold mode is active ( displayed):
▶ Press the man key.
The desired room temperature then appears on the display for a few seconds. An
indication that the current setting is being held (unlimited time) then appears on the
display for a few seconds.
If it is too cold or too warm for you today: Change the room temperature temporarily
Auto mode
▶ Turn the dial in order to set the desired room temperature.
▶ Press the dial (or wait a few seconds).
The setting value stops flashing. The user interface operates with the modified
settings.
The change applies until the next switching time in the active time program is reached
( Chapter 5.3, Page 12). The temperature stored in the automatic mode then
becomes active again.
Should it be permanently too cold or too hot for you:
Change the required room temperature for the Heating or Setback mode
Auto mode
▶ Press the menu key to open the main menu.
▶ If necessary, turn the dial to highlight the Heating menu.
▶ Press the dial to open the Heating menu.
Notice: Continued on page 8.
Table 4 Getting started – Room temperature
6 720 811 158-03.1O
Set Room Temp
6 720 811 158-04.2O
Hold
6 720 811 158-05.1O
to 11:00 pm
6 720 811 158-06.1O
Temperatures
To Next Page
Loading...
