Digital Video Recorder 440/480 Series Archive Player | en 85
Bosch Security Systems Installation and Operation manual AM18-Q0605 | v2.0 | 2012.04
8.5.1 Capturing a still image
Capture still images from the full screen display of a camera and save them to the PC hard
disk in a bitmap format.
To save an image from the active cameo to the PC hard disk:
1. Click the Capture button;
– The Snapshot pop-up window appears.
2. To change the default location, browse to the location in the PC file system where the
image file is to be stored.
3. Type a new name for the file to change the file name.
4. Click Save.
Authentication information is shown under the image.
8.6 Find image
Figure 8.4 Archive Player - date and time fields and Go button
1. Fill in a date and time.
2. Click the Go button;
– Playback starts at the specified date and time.
8.7 Video slider bar
The video slider bar shows the relative playback time within the video interval and allows its
adjustment.
8.8 Checking authenticity
1. Click the Check button to verify the authenticity of the archive:
– A progress bar will be displayed if the check takes some time.
– An information window indicates the authenticity of the archive.
Verifying individual frames
For authenticity verification of individual frames, pause playback and then click the
information button. This opens the Authenticity information window. This window shows
details of the video frame shown in the cameo when it was clicked.
8.9 Exit button
Click the Exit button to stop using the Archive Player.
To Next Page
Loading...
