Bosch FLEXIDOME IP indoor 8000i - Network Connection and Wiring; Network Cable Wiring Instructions; Power over Ethernet (PoE) Device Notice

10 en | Preparing for installation FLEXIDOME IP indoor 8000i
2021-08 | 01 |
Installation manual
Bosch Security Systems B.V.
Quantity Component
1 Quick installation guide
1 Safety information
3 Identification label sticker
Make sure that:
– All parts are included and without damage.
– The necessary cable is ready for use (refer to Wiring, page 10 for more information):
network cable, shorter than 100m.
4.3 Wiring
Connect the camera to a 10/100 Base-T network:
– Use STP Category 5e (or higher) network cable shorter than 100m with RJ45 connectors
(the camera network socket is AutoMDIX compliant).
– Power is supplied to the camera through the network cable compliant with the Power-
over-Ethernet standard.
i
Notice!
Use only PoE approved devices.