Bosch FLEXIDOME IP indoor 8000i - Conduit Cover Installation and Camera Wiring; Conduit Cover and Camera Module Preparation; Camera Module Network Wiring

FLEXIDOME IP indoor 8000i Hardware installation | en 17
Bosch Security Systems B.V.
Installation manual
2021-08 | 01 |
10. Drill the 4 holes with the appropriate diameter drill to support your 5-6mm (0.2inch)
screws and plugs.
11. Install 4 plugs in the holes.
12. Attach the mounting plate to the surface with 4 screws. Tighten the screws between 4
and 7Nm (3 and 5.2lbfft).
13. Install the conduit cover on the conduit plate with the bolt. Tighten the screw between
1.4 and 2Nm (1lbfft and 1.5lbfft).
14. Prepare camera module and remove the conduit door.
6.2 Wiring the camera module
1. Remove the camera module from the box.