FLEXIDOME IP indoor 8000i Maintenance | en 39
Bosch Security Systems B.V.
Installation manual
2021-08 | 01 |
For instructions on how to replace the bubble, refer to the respective Quick Installation Guide.
10.4 Camera reset
To reset the camera to factory settings:
1. If the camera is already mounted, remove the camera module from its mounting plate.
2. Unscrew the thumb screw of the microSD card compartment. No tools are needed.
3. Open the lid of the microSD card compartment.
1. Press tightly and hold the reset button for 15 seconds.
The LED light by the reset button flashes in red when reset action is triggered.
To Next Page
Loading...
