Bosch FLEXIDOME IP indoor 8000i - Mounting Plate Installation With Conduit; Conduit Mounting Plate Installation Steps

FLEXIDOME IP indoor 8000i Hardware installation | en 15
Bosch Security Systems B.V.
Installation manual
2021-08 | 01 |
3. Drill the 4 holes with the appropriate diameter drill to support your 5-6mm (0.2inch)
screws and plugs.
4. Install 4 plugs in the holes.
5. Put the cable through the center hole of the mounting plate.
6. Attach the mounting plate to the surface with 4 screws. Tighten the screws between 4
and 7Nm (3 and 5.2lbfft).
6.1.2 Installing the mounting plate with conduit
– For a camera mounted on a wall: make sure that the mounting plate is oriented in a
90º angle, with the holes parallel to the floor, for proper alignment of mounting
screws and logos.