Bosch FLEXIDOME IP starlight 8000i - 4.3.1 Network and PoE power; 4.3.2 24 V AC; 12-26 V DC power input

14 en | Preparing for installation FLEXIDOME IP starlight 8000i
2024-02 | V02 | F.01U.404.121
Installation manual
Bosch Security Systems B.V.
When PoE power returns, the camera seamlessly switches back to PoE as its default power
source.
4.3.2 24V AC / 12-26V DC power input
Connect a SELV-LPS or a SELV Class2 power supply with a rated supply voltage of 24VAC
or 12-26VDC.
i
Notice!
When using a 24VAC power supply, do not make a ground connection with one of the
24VAC supply leads. This will damage the camera.
4.3.3 10-pin I/O connector
Pin Connection
1 +12VDC out
2 GND
3 ALARM OUT
4 ALARM OUT
5 GND
6 ALARM IN 1
7 ALARM IN 2
8 GND
9 AUDIO IN
10 AUDIO OUT
12VDC power output
The 12VDC output can be enabled/disabled via the web interface, and controlled via the
Alarm Task Editor.
Maximum load of 50mA.
Alarm I/O
1. Input:
Use the alarm input to connect external alarm devices such as door contacts or
sensors:
– TTL logic, +5V nominal, +40VDC maximum, DC coupled with 50kOhm pull-up to
+3.3V.
– Configurable as active low or active high.
Use a zero potential make-contact or switch as the actuator (with a bounce-free contact
system).
2. Output:
Use the alarm output for switching external devices such as lamps or sirens. The alarm
output switching capability has a maximum voltage of 30VAC or +40VDC; maximum
0.5A continuous, 10VA.