Bosch FLEXIDOME IP starlight 8000i - 6.1.1 Installing the mounting plate without conduit

18 en | Hardware installation FLEXIDOME IP starlight 8000i
2024-02 | V02 | F.01U.404.121
Installation manual
Bosch Security Systems B.V.
6.1 Installing the mounting plate
The mounting plate is used to fix the camera to a flat surface. It offers different holes and
slots for a variety of fixing options.
5
3
1 10.2cm / 4in. Square junction box 2 Pole mount (NDA-U-PMAL/NDA-U-
PMAS)/Corner mount (NDA-U-CMA)
3 Single gang box or universal slot,
45mm / 1.8in to 85mm/3.3in
4 Double gang box
5 Ceiling/wall mount and pendant
interface plate (NDA-8000-PIP(W))
Note: Only options 1, 2, and 5
maintain IK10+ rating
Installation options
The camera has two configurations for surface mounting:
– Refer to Installing the mounting plate without conduit, page 19, if the wires are not on
the outside of the surface.
– Refer to Installing the mounting plate with conduit, page 20, if the wires are on the
outside of the surface.
Additionally, the camera can cover various mounting options when combined with the
available accessories. See the Mounting accessories, page 30 chapter for the available
accessories.
i
Notice!
The plugs and screws for surface mounting are not supplied with the camera.