40 en | Maintenance FLEXIDOME IP starlight 8000i
2024-02 | V02 | F.01U.404.121
Installation manual
Bosch Security Systems B.V.
Clear bubbles offer maximum sensitivity by allowing as much light through as possible.
Tinted bubbles offer covertness by making it difficult to see from the outside the direction
the camera is facing.
For instructions on how to replace the bubble, refer to the respective Quick Installation
Guide.
10.4 Camera reset
To reset the camera to factory settings:
1. Remove the camera module from the camera base.
2. Unscrew and remove the connection PCB from the camera base.
3. Attach the connection PCB to the camera module.
4. Connect a network cable with PoE or a 24VAC / 12-26VDC cable to power the camera
module.
5. Press tightly and hold the reset button on top of the SD card slot for 15 seconds. The
LED light by the reset button flashes in red.
To Next Page
Loading...
