English–31 609 929 F69 • (04.10) PS
Avoid overloading the motor especially when working
with large work pieces. Apply only light pressure to the
handle when sawing.
For machine models with saw blade brakes: When the
electro#tool is switched off, the braking of the saw
blade causes a downward movement of the tool arm.
Take this reaction force into consideration when
switching off the electro#tool in the upper position.
Caution! The saw blade continues to run after the
electro#tool is switched off.
Protect the saw blade from strikes and shocks. Do not
apply side pressure to the saw blade.
Use only sharp, flawless saw blades. Change
cracked, bent or dull saw blades without delay.
Select a saw blade suitable for the material to be
worked.
Use only saw blades recommended by the manufac#
turer of the electro#tool.
Observe the instructions of the manufacturer for the
mounting and usage of the saw blade.
Actuate the spindle lock only when the saw blade is at
a standstill.
The saw blade becomes very hot while working; do
not take hold of it until it has cooled.
Wear protective gloves to avoid injury from the sharp
cutting edges of the saw blade during changing the
saw blade.
Observe the dimensions of the saw blade. The hole di#
ameter must fit the tool spindle without play. Do not
use reducer pieces or adapters.
Observe the maximum allowable speed of the saw
blade.
Saw blades of highly alloyed high speed steel (HSS
steel) are not to be used.
Remove the sawdust regularly from the carbon brush
holder of the electric motor by blowing out with com#
pressed air.
Bosch can ensure flawless functioning of the machine
only when original accessories intended for the ma#
chine are used.
SYMBOLS
Important notice: Some of the following symbols could have meaning for the use of your tool. Please take note
of the symbols and their meaning. The correct interpretation of the symbols will help you to use the tool in a better
and safer manner.
Symbol Name Meaning
VVolts Voltage
A Amperes Current
Ah Ampere#hours Capacity, quantity of stored electrical energy
Hz Hertz Frequency (cycles per second)
WWatt Power
Nm Newton#meter Unit of energy
kg Kilograms Mass, weight
mm Millimetre Length
min/s Minutes/Seconds Time
°C/°F Degrees Celsius/Degrees
Fahrenheit
Temperature
dB Decibel Unit of relative loudness
∅ Diameter Size of drill bits, grinding wheels, etc.
min
#1
/n
0
Revolutions per minute/no load
speed
Rotational speed at no load
…/min Revolutions or reciprocation per
minute
Revolutions, strokes, surface speed, orbits, etc.
per minute
0 Off position Zero speed, zero torque...
To Next Page
Loading...
