Bosch INTEGRUS

To Next Page

To Previous Page

Integrus Index | en 87

Bosch Security Systems B.V. Installation and Operation manual IOM-INT_en | V0.1 | 2010.06

Index

Main Page

Table of Contents3
Safety6
About this Manual7
Purpose7
Digital Document7
Intended Audience7
Related Documentation7
Alerts and Notice Signs7
System Overview8
Integrus Transmitters9
Audio Interface Modules10
Integrus Radiators11
Medium and High Power Radiators11
Low Power Wide Beam Radiator12
Integrus Receivers14
Receiver Headphones15
Integrus Charging Units15
Planning16
System Technology16
IR Radiation16
Signal Processing16
Quality Modes17
Carriers and Channels17
Aspects of Infra-Red Distribution Systems18
Directional Sensitivity of the Receiver18
The Footprint of the Radiator18
Ambient Lighting20
Objects, Surfaces and Reflections20
Positioning the Radiators21
Overlapping Footprints and Multipath Effects23
Planning an Integrus Infra-Red Radiation System24
Rectangular Footprints24
Planning Radiators25
Cabling26
Installation28
Integrus Transmitters28
Audio Interface Modules28
Upgrading Transmitter Lbb4502/XX to INT-Tx/XX29
Removing the Main PCB and the Rear Panel29
Installation of the INTK31
Medium and High Power Radiators33
Attaching the Suspension Bracket33
Mounting on a Floor Stand34
Wall Mounting35
Ceiling Mounting36
Mounting on Horizontal Surfaces37
Low Power Wide Beam Radiator37
Integrus Charging Units37
Connection39
Integrus Transmitters39
Connecting the DCN Next Generation39
Connecting the DCN System39
Connecting Other External Audio Sources40
Connecting an Emergency Signal40
Connecting to Another Transmitter41
Integrus Radiators41
Configuration43
Using the Transmitter Menu43
Overview43
Navigate through the Menu44
Examples45
Setup the Transmitter51
Main Menu51
Set Transmission Mode51
Set Network Mode52
Set Number of Channels52
Set Channel Quality and Assign Inputs to Channels53
Set Channel Names54
Disable or Enable Carriers55
View Carrier Assignments55
Configure Auxiliary Inputs56
Set Sensitivity of the Inputs56
Enable / Disable IR-Monitoring57
Enable / Disable Headphone Output57
Choose Transmitter Name57
Reset All Options to Factory Default Values57
Integrus Radiators58
Setting the Output Power Selection Switch58
Setting the Delay Switches58
Determining the Radiator Delay Switch Positions58
System with One Transmitter59
System with Two or more Transmitters in One Room61
Systems with more than 4 Carriers and a Radiator under a Balcony63
Testing the Coverage Area63
Operation68
Integrus Transmitter68
Start-Up68
View Transmitter Status68
View Fault Status68
Set Monitoring Options69
View Version Information70
Integrus Radiators70
Integrus Receivers70
Normal Operation70
Reception Test Mode71
Integrus Charging Units72
Maintenance77
Troubleshooting77
Technical Data79
Electrical Data79
Overall System Characteristics79
Transmitters and Modules79
Radiators and Accessories80
Receivers, Battery Packs and Charging Units80
Glossary80
Cables and Connectors81
Mechanical Data82
Transmitters and Modules82
Radiators and Accessories82
Receivers, Battery Packs and Charging Units83
Ambient Conditions83
Overall System Conditions83
Rules and Standards84
Overall System Conformance84
Guaranteed Rectangular Footprints85
Index87

Bosch INTEGRUS - Index

Table of Contents

Other manuals for Bosch INTEGRUS

Related product manuals