Bosch KTS 3a Series - Interface protocols; Power supply unit

1 689 989 293 2020-08-24| Robert Bosch GmbH
Technical Data | KTS 350 (KTS 3a Series) | 27 |
9.5 Interface protocols
The following interfaces and their associated protocols
are supported for control unit diagnosis in compliance
with ISO 15031:
R ISO 15031, ISO 22900
R SAE J2534-1 and -2 (PassThru)
R ISO 13400 (Diagnostic over IP)
R ISO 9141-2 (communication lines K and L)
R SAE J1850VPW and SAE J1850PWM
(communication lines BUS+ and BUS-)
R CAN ISO 11898 ISO 15765-4 (OBD)
(communication lines CAN-H and CAN-L)
R CAN Single Wire, CAN Low Speed and additional
vehicle-specific special protocols
i KTS 350 (KTS 3a Series) may be used for Euro
5-compatible vehicles with the PassThru Standard.
9.6 Power supply unit
Property Value / range
Input voltage (AC) 100 – 240 VAC
Frequency 50 / 60 Hz
Input current 1.6 A
Output voltage (DC) 12 V
Max. output current 5.0 A
en