How to troubleshoot a Bosch CRS 845 Test Equipment with LED off?
If the LED is off on your Bosch Test Equipment, check the 24 Volt power supply and the F1 fuse. Also, verify there is a connection to the rail PCVs and check the connection.
What to do if the LED is off on my Bosch CRS 845 Test Equipment?
If the LED is off on your Bosch Test Equipment, check the power supply and the F3 fuse.
What to do if the LED on my Bosch Test Equipment is only on for 1 second?
If the LED on your Bosch Test Equipment is only on for 1 second, close the spray guards and check the safety monitoring.
How to fix a Bosch CRS 845 when the LED is off?
If the LED is off on your Bosch Test Equipment, install new firmware or replace the control PCB.
General| Brand | Bosch |
|---|---|
| Model | CRS 845 |
| Category | Test Equipment |
| Language | English |
Lists required tools and equipment for installation and repair procedures.
Details the assembly and disassembly of the anti-splash housing and its guards.
Explains the safety monitoring system components and their integration.
Describes the mounting panel, high-pressure rail, and distributor assembly.
Details the assembly and components of the control device.
Illustrates the assembly of the overflow control valve.
Describes the single-stage filter as a special accessory for CP2.
Provides a comprehensive overview of the hydraulic system.
Details the hydraulic system overview specifically for CP1.
Details the hydraulic system overview specifically for CP2.
Details the hydraulic system overview specifically for CP 3.x.
Presents an overview of all electrical connection variants for the system.
Details the various pump connection variants for CP2 and CP3.
Lists all equipment components related to the EPS.
Lists all equipment components specific to the CRS 845.
Lists the equipment used for safety monitoring functions.
Lists the various components that make up the control unit.
Lists the components associated with the cooler.
Troubleshooting guide for the control device, including LED indicators.
Procedures for checking the 12V and 24V power supply to the control device.
Details the internal connecting cables and their diagrams for the control PCB.
Details external connecting cables and adapter lines for various pump types.
Step-by-step procedure to check the functionality of the safety monitoring system.
Procedure to check the pressure control valves for resistance and leaks.
Procedure to check the B9 and B10 pressure sensors and their output signals.
Step-by-step instructions for replacing the A10 control printed circuit board.
Procedure for replacing the inductive proximity switches on the anti-splash guards.
Instructions for removing and installing a new high-pressure rail.
Procedure for replacing the pressure limiting valve.
Guidance on replacing the high-pressure feed connection.
Steps for removing and installing a new pressure control valve (PCV).
Procedure for replacing the B9 pressure sensor.
Procedure for replacing the B10 pressure sensor.
Presents the hydraulic circuit diagrams for the test system.
Presents the electrical circuit diagrams for the test system.
To Next Page
