PI - 32.15aProduct Documentation of the LSN Radio Fire Detection System
Seite 30 von 32
601-F.01U.002.708
A3.en / 28.12.2004
ST-FIR/ PRM1 / deh
11. Troubleshooting
If you experience problems with initial-set up, DLC support should
generally be contacted before modules are exchanged!
Problem Solution
The LED on the
detector flashing
rapidly when the
batteries are inserted.
d Press the new button on the back of the detector and
hold it for at least 3 seconds. This resets the detector.
LEDs on the RF
expansion module
flashing without
definition.
d Reset the RF expansion module using the WinPara
parameterization module or reset it manually,
see page 17 and page 23.
To Next Page
Loading...
