Pack201 | Operator Instructions | Section 3
EN | 3
© Bosch Packaging Technology, Inc.
All rights reserved 2012
13� Close the power feed roll (optional)�
14� Release the Emergency Stop button� There is
a two-second delay before the wrapper can be
started�
15� Jog the wrapper until the sealing material is
through the endseal�
Set Up Production
1� Select the desired recipe for the production run�
See Section 4 Operator Interface for a detailed
description�
2� Select the desired functions/parameters for the
production run�
3� Push the START button and run the wrapper for a
series of packages, then push STOP�
4� Examine the packages to make sure the lm is
centered and sealing properly�
5� Make adjustments to nseal and/or the endseal
components as needed�
6� Once everything is sealing properly, push START
and begin production�
To Next Page
Loading...