Pack201 | Operator Instructions | Section 3
EN | 5
© Bosch Packaging Technology, Inc.
All rights reserved 2012
3.3 End of Production
1� Push the STOP button to bring the wrapper to a
cycle stop�
2� Place the main disconnect in the OFF position�
3� Turn off the compressed air�
4� Remove all product from the infeed conveyor and
the feeder�
5� Open the nwheels and allow the heated elements
to cool�
6� Remove the lm from the sealing table.
7� Perform cleaning and/or maintenance according to
Section 6 of this manual�
To Next Page
Loading...