Bosch Pack201HS - 3.4 Troubleshooting

Pack201 | Operator Instructions | Section 3
EN | 6
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Problem: The wrapper does not run.
Possible Cause Solution
The wrapper is not receiving power from a power
source
Check that the wrapper is connected to the power supply�
The electrical disconnect switch is in the OFF
position
Turn the main electrical disconnect to the ON position�
A guard or cabinet is open Close the guard or cabinet
The EMERGENCY STOP button has been pressed Pull out the EMERGENCY STOP button�
Main circuit breaker tripped� Reset main circuit breaker�
An electrical connection is loose or open Have a qualied electrician check the electrical connec-
tions�
A motor has been overloaded Call Bosch for instructions to reset the motor�
A motor is faulty Call Bosch to order a replacement motor�
3.4 Troubleshooting
If the wrapper is not operating properly, consult the
following problem descriptions, their associated
causes), and solutions� If you are having a problem
that is not listed here, contact Bosch for additional
information and/or service�
Problem: A Finwheel is not being heated.
Possible Cause Solution
The Finwheel heating element connections are
loose
Have a qualied electrician tighten the heating element
connections�
The Finwheel thermocouple connections are
loose
Have a qualied electrician tighten the thermocouple con-
nections�
The Finwheel temperature controller connections
are loose
Have a qualied electrician tighten the temperature con-
troller connections�
The Finwheel heating element is faulty Replace the heating element�
The Finwheel thermocouple is faulty Replace the heating element containing the thermocouple�
The Finwheel temperature controller is faulty Have a qualied electrician replace the temperature con-
troller�
Faulty solid state relay� Using the electrical schematics, have a qualied electrician
check it out and/or consult Bosch�
The Finwheel collector ring assembly is faulty� Have a qualied electrician check the collector rings and
brushes and replace if necessary�