Bosch PLENA PLN-6AIO240 - Call Station Connections

Call Station connections
The following figure lists all items of the Call Station. This section only describes the items
used for connecting the Call Station. For information on configuring and operating the Call
Station, refer to
– Call Station hardware configuration, page 24
– Call Station software configuration, page 25
– Call Station operation, page 38
7
9
1
2
4
5
126
8
11 10
3
Figure 6.4: PLN‑6CS Call Station connections
Number
Item Description
6 Reserved Not used.
9 RJ45 connector
(input)
Use a standard shielded or unshielded Cat-5 cable to connect the call
station to the All‑in‑One Unit or to the previous call station, connected
in cascade.
10 RJ45 connector
(loop-through)
Use a standard shielded or unshielded Cat-5 cable to connect the call
station to the next call station, connected in cascade. The RJ45
connectors (9) and (10) are in parallel and their functions can be
interchanged.
The last Call Station in the chain must have a terminator plug in the free
RJ45 socket for best performance with long cables. A small terminator
plug that looks like an ordinary RJ45 connector is delivered with each
Call Station. See Delivered with products, page 11.
When Call Stations are cascaded some terminators are left unused, as
only the last Call Station is terminated.
6.3
18 en | Connection Plena All-in-One System
2014.09 | V1.2 | Installation and Operating Manual Bosch Security Systems B.V.