Packaging and transportation
Before using the Plena All‑in‑One System, read this section to make sure you have
all components for connecting and operating the system.
Unpacking
– This equipment should be unpacked and handled with care.
– If an item appears to be damaged, notify the shipper immediately.
– Carefully peel off the protective plastic film from the displays.
Caution!
Do not use sharp or pointed objects.
– If any items are missing, notify your Bosch representative.
– The original packaging is the safest container in which to transport products and can be
used to return products for service if necessary.
Delivered with products
PLN‑6AIO240 Plena All-in-One Unit
Quantity Component
1 All‑in‑One Unit
1 m Cat‑5 cable with RJ45 termination for adaptor
1 Adaptor to connect a PLE‑1CS or PLE‑1SCS desktop microphone via
shielded Cat‑5 wiring
1 AC power cord (for European mains sockets)
1 Safety Instructions
1 AM indoor antenna
1 Coax connector for FM antenna
1 Pair of brackets for 19“ rack installation
1 Remote control unit (without batteries)
1 Installation and Operating Manual
PLN‑6CS Plena All-in-One Call Station
Quantity
Component
1 All‑in‑One Call Station
1 m Cat‑5 cable with RJ45 plugs
1 Terminator plug
PLN‑4S6Z Plena All-in-One Wall Panel
Quantity
Component
1 All‑in‑One Wall Panel
1 m Cat‑5 cable with RJ45 plugs
4
4.1
4.2
Plena All-in-One System Packaging and transportation | en 11
Bosch Security Systems B.V. Installation and Operating Manual 2014.09 | V1.2 |
To Next Page
Loading...
