Call Station hardware configuration
The following figure lists all items of the Call Station. This section only describes the hardware
configuration of the Call Station. For information on connecting and operating the Call Station,
refer to
– Call Station connections, page 18
– Call Station operation, page 38
The programmable features of the call station are explained in Call Station software
configuration, page 25.
Figure 7.2: Call Station
Number
Item Description
8 Output level adjust Use a small screwdriver to adjust the call station output level. This
setting determines how loud a call is in the zones and is independent of
the master volume setting of the All‑in‑One Unit to make sure that each
call comes through.
7.2
24 en | Configuration Plena All-in-One System
2014.09 | V1.2 | Installation and Operating Manual Bosch Security Systems B.V.
To Next Page
Loading...
