Call Station operation
The following figure lists all items of the Call Station. This section only describes the operation
of the Call Station. For information on connecting and configuring the Call Station, refer to:
– Call Station connections, page 18
– Call Station hardware configuration, page 24
– Call Station software configuration, page 25
The PLN‑6CS Call Station is used for making announcements to selected zones of the
All‑in‑One system.
Figure 8.6: PLN‑6CS Call Station functions
Number
Item Description
1 Goose neck condenser
microphone
A high quality unidirectional microphone.
2 Zone buttons / Zone LEDs
(1-6)
– To select a zone, press a zone button and the corresponding zone
LED will go on.
– To deselect a zone, press the zone button again and the zone LED
will go out.
8.3
38 en | Operation Plena All-in-One System
2014.09 | V1.2 | Installation and Operating Manual Bosch Security Systems B.V.
To Next Page
Loading...
