Bosch PLENA PLN-6AIO240 - Music player and SD card operation

SD card slot
Only use high capacity SD cards (HCSD) up to 32 GB for this unit.
To use the SD card slot (4):
1. Insert the SD card into the SD card slot.
2. Press Standby to power on the music source, and/or press USB/SD to select the SD
device.
3. While the music player is reading the content of the SD card, the LCD displays 'SD'
flashing:
– If the content reading is successful, the first track found will be played.
– If the content reading is unsuccessful, the LCD displays ‘none’.
4. When playing from the SD card has finished, the player will resume playback from the
tuner automatically.
Notice!
The USB connector and SD card slot support devices up to 32 GB in FAT32 format or up to
4 GB in FAT16 format. MP3 files can be between 32 .. 320 kbps.
Music player
General music player button functions are explained in the table below. For the location of
each button, see item 5 in Section Internal music unit, page 32.
Button Function Instructions
Stand-by Power the audio
player on or off
Press the Stand-by button to power on the audio player.
The unit resumes playing from the last state it was in
before the unit was switched off. This state will be shown
on the LCD. Press the stand-by button again to switch
the player off. The LCD will turn off and all other
functions are cancelled.
USB/SD USB/SD select
button
Press the USB/SD button to select between USB or SD
card.
Tuner Tuner select
button
Press the Tuner button to select the Tuner mode.
Table 8.1: General audio unit button functions
The following table explains button functions that are used when the music player is in MP3
playback mode. For the location of each button, see item 5 in Section Internal music unit, page
32.
8.2.4
8.2.5
34 en | Operation Plena All-in-One System
2014.09 | V1.2 | Installation and Operating Manual Bosch Security Systems B.V.