Remote control button functions
The following illustration shows the layout of the remote control function buttons.
Figure 8.5: Remote control functions
All remote control button functions are the same as described for the music player, except for
the following buttons that are only available on the remote control. See Music player, page 34.
Button
Function Instructions
0 - 9 + Enter Select a specific song
number or radio
frequency
In USB/SD playback mode:
Use the numeric buttons to enter the number of
the song to be played. The first two digits select
the folder; the next three digits select the song.
Then press Enter to start playback.
In Tuner mode:
Use the numeric buttons to enter the frequency
of the radio station, then press Enter to tune to
that frequency. If the frequency is invalid, the
tuner returns to its previous state.
CLR Clear selection Press CLR to cancel the process of selecting a
specific song number or radio frequency and
return to the previous state.
Search Search and store radio
stations
In tuner mode: press Search for more than 5
seconds, then the tuner starts searching for
radio stations and stores the first ten stations in
M1-M10. Pressing any key interrupts the search
process.
Table 8.4: Remote control button functions
8.2.6
Plena All-in-One System Operation | en 37
Bosch Security Systems B.V. Installation and Operating Manual 2014.09 | V1.2 |
To Next Page
Loading...
