The following buttons are used when the music player is in FM/AM tuner mode. For the
location of each button, see item 5 in Section Internal music unit, page 32.
Button Function Instructions
FM/AM Switch between
FM and AM
bands / select
region mode
– To switch between FM/AM bands, press the FM/AM
button. The LCD shows “AM” or “FM”.
– To select a different region mode, press FM/AM for
more than 3 seconds, the LCD shows "EUR" or
"USA". Change the current setting by pressing Skip
forward, and then press Memory to store this
setting. This will change the tuning grid to scan for
radio stations. Other regions may adhere to the USA
or European standard.
Tuner Fine tune / scan
FM/AM radio
frequencies
– To fine tune an FM/AM frequency, use the Tuner up
and down buttons.
– To scan FM/AM frequencies, press the Tuner up or
down buttons for at least 2 seconds to start an
automatic scan search. Scanning stops when the
FM/AM tuner can lock on to a strong radio station
frequency.
Memory Memory setting Saves the FM/AM mode and frequency pre-selections M1-
M10.
M1‑M5 Pre‑selection Five frequency pre‑selection buttons.
To set a frequency pre‑selection:
1) Search and hold the frequency.
2) Press the Memory button.
3) Press a pre‑selection button (Mx) for more than 1
second.
To recall a pre-selected radio station press Mx for pre-
selections M1-M5.
+5 Pre‑selection Frequency 6‑10 pre‑selection button.
To set a frequency pre‑selection 6‑10:
1) Search and hold the frequency.
2) Press the Memory button.
3) Press the +5 button.
4) Press a pre‑selection button (Mx) for more than 1
second.
To recall a pre-selected radio station press +5 and then
Mx for pre-selections M6-M10.
Table 8.3: FM/AM Tuner button functions
36 en | Operation Plena All-in-One System
2014.09 | V1.2 | Installation and Operating Manual Bosch Security Systems B.V.
To Next Page
Loading...
