Wall Panel operation
This section only describes the operation of the Wall Panel. For information on connecting and
configuring the Wall Panel, refer to:
– Wall Panel connections, page 20
– Wall Panel configuration, page 28
The PLN‑4S6Z Wall Panel is used to remotely control the All‑in‑One Unit. The Wall Panel is
connected to the All-in-One Unit with a Cat-5 cable and can take over operational control of
the All-in-One Unit. Pressing the Enable button toggles between control on the front panel of
the All-in-One Unit or control via the Wall Panel. The Wall Panel is capable of selecting a music
source, selecting the zones that receive the music and it can control the master volume.
It also provides a microphone and line input with level control as a remote input for the All-in-
One System.
Number
Item Description
1 Zone 1-6 buttons / Zone 1-6
LEDs
– To select a zone, press a zone button and the corresponding zone
LED will go on.
– To deselect a zone, press the zone button again and the zone LED
will go out.
2 All call button – To select all zones press the All button, all zone LED lights will go
on.
– To deselect all selected zones, press the All button again, the zone
LEDs will go out.
3 Music source selector Press the SELECT button repeatedly to select between the internal
music player of the All‑in‑One Unit (USB/SD/Tuner) and Music inputs
1-3. The corresponding LED lights up to show the selection.
8.4
40 en | Operation Plena All-in-One System
2014.09 | V1.2 | Installation and Operating Manual Bosch Security Systems B.V.
To Next Page
Loading...
