page heading
2 SAVE THESE INSTRUCTIONS
Table of Contents
Safety Symbols ........................2
General Power Tool Safety Warnings .......3
Safety Warnings for Cordless
Nailer Tools ...........................5
Additional Safety Warnings ..............5
Disposal .............................7
Intended Use ..........................7
Speciļ¬cations .........................8
Fastener Selection .....................9
Symbols .............................10
Getting to Know Your GNB18V-12
Concrete Nailer .......................11
Unpacking and Checking Contents .......13
Unpacking the Nailer ..................13
Assembly ............................14
Removing and Installing the
Magazine and Nosepiece ...............14
Removing and Attaching the
Supporting Leg ......................15
Inserting and Removing
the Battery Pack .....................16
Utility Hook .........................16
The definitions below describe the level of severity for each signal word.
Please read the manual and pay attention to these symbols.
!
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
Operation ...........................17
Daily Inspection and Testing ............17
Work Surface Suitability and
Center Punch Test ....................17
Loading Collated Magazine .............18
Dry Fire Lock Out .....................18
Loading Single Shot Fasteners ...........19
User Interface .......................20
Trigger Lock .........................21
Built-in Work Light ....................21
Depth of Drive Adjustment .............21
Nailer Actuation ......................22
Maintenance .........................23
General Maintenance ..................23
Service .............................23
Cleaning ...........................23
Repairs ............................23
Accessories ..........................24
Troubleshooting ......................24
Jam Clearing ........................24
Safety Symbols
1605A001CD GNB18V-12 202301.indd 2 1/9/23 2:07 PM
To Next Page
Loading...
