Bosch rexroth A21VG 10 Series - Page 10

10/56 Safety instructions
Bosch Rexroth Corporation, A21VG Series 10, RE 93223-01-B/09.2020
• Ifunsuitable products are installed or used in applications that are ofrelevance
tosafety, unexpected operating conditions may occur in the application, which
could result in personal injury or property damage. For this reason, only use
theproduct in safety-relevant applications if this use isexpressly indicated
and approved in the product documentation, e.g. inexplosion protection areas
orinsafety-related parts of a control system (functional safety).
• Only commission theproduct if it has been determined that theend product (e.g.
machinery/system) in which the Rexroth products are installed complies with the
country-specic provisions, safety regulations and standards for the application.
• Use tools appropriate for the work being performed and wear appropriate
protective clothing to prevent punctures and cuts (e.g. when removing protective
covers, disassembly).
• There isarisk ofentanglement when operating theaxial piston unit with
abare shaft end. Check whether or not your machine requires additional safety
measures for your application. If necessary, make sure these are appropriately
implemented.
• Depending on the type of control used, electromagnetic effects can beproduced
when using solenoids. Applying a direct voltage signal (DC) to solenoids does not
create electromagnetic interference (EMI) nor is the solenoid affected byEMI.
Potential electromagnetic interference (EMI) exists if the solenoid isenergized
with a modulated direct current (e.g. PWMsignal). Appropriate testing and
measures should be taken by the machine manufacturer toensure other
components oroperators (e.g. with pacemaker) are not affected bythis potential.