Bosch rexroth A21VG 10 Series - Personal protection equipment

Safety instructions 13/56
RE 93223-01-B/09.2020, A21VG Series 10, Bosch Rexroth Corporation
CAUTION
High noise development during operation!
Danger ofhearing damage, hearing loss!
The noise emission ofaxial piston units depends onrotational speed, working
pressure and installation conditions, among other factors. The sound pressure
level may rise above 70 dB (A) incertain application conditions.
▶ Always wear hearing protection near arunning axial piston unit.
Hot surfaces onaxial piston unit!
Risk ofburning!
▶ Allow theaxial piston unit tocool down sufciently before touching it.
▶ Protect yourself with heat-resistant protective clothing, e.g. gloves.
Inappropriate routing ofcables and lines!
Risk ofstumbling and property damage! Improper routing ofcables and lines
can cause arisk ofstumbling aswell asdamage toequipment and components,
e.g.due tolines and connectors being torn off.
▶ Always install cables and lines inaway that nobody can fall over them, that
they are not bend ortwisted, do not chafe onedges and are not guided
through ducts with sharp edges without sufcient protection.
Contact with hydraulic uid!
Danger tohealth / damage tohealth, e.g. eye injury, skin damage, toxication
inthe event ofinhalation!
▶ Avoid any contact with hydraulic uids.
▶ When handling hydraulic uids, thesafety instructions ofthelubricant
manufacturer need tobe observed atall times.
▶ Use your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ Immediately seek medical attention, however, ifhydraulic uid gets into your
eyes orblood circuit orif you swallow itaccidentally.
Escaping hydraulic uid through leaking machine/system components!
Risk ofburning and risk ofinjury due toescaping hydraulic uid jet!
▶ Depressurize therelevant machine/system component and repair theleak.
▶ Never attempt toblock orseal theleak orhydraulic uid jet with acloth.
Danger from improper handling!
Slip hazard! Risk ofslipping onwet surfaces when climbing onthe axial piston
unit.
▶ Never grab orclimb onto theaxial piston unit.
▶ Check how tosafely get ontop ofthemachine/system.
2.7 Personal protection equipment
The personal protection equipment is the responsibility of the user of the axial
piston unit. Observe the safety regulations and provisions of your country.
All components of the personal protection equipment must be intact.