BoschRexrothAG, RE91405-01-B/2021-05-21
12/52 A2FO series 70 | Safety instructions
WARNING
Escaping hydraulic fluid mist!
Risk of explosion and fire hazard, health hazard, risk of environmental pollution!
▶ Depressurize the relevant machine/system component and repair the leak.
▶ Only perform welding work when the machine/system is depressurized.
▶ Keep open flames and ignition sources away from the axial piston unit.
▶ If axial piston units are located in the vicinity of ignition sources or powerful
thermal radiators, ashield must be erected to ensure any escaping hydraulic
fluid cannot be ignited, and to protect hose lines from premature aging.
Escaping hydraulic fluid due to leakage of machine/system components!
Risk of burning and risk of injury due to escaping hydraulic fluid jet!
In case of leakage at the axial piston unit, high-pressure fluid jets may escape.
▶ Depressurize the relevant machine/system component and repair the leak.
▶ Never attempt to block or seal the leak or hydraulic fluid jet with acloth.
Hydraulic fluid will explode when making contact with water!
Explosion and fire hazard!
▶ Do not bring hot hydraulic fluids in contact with water.
Electrical voltage!
Danger to life or risk of injury due to electric shock or property damage!
▶ Always diskonnect the voltage supply to the relevant machine/system part before
assembling the product and/or connecting or diskonnecting the connector.
Protect the machine/system against being re-energized.
To Next Page
Loading...
Need help?
General
