Bosch rexroth A2FO Series User Manual

RE91405-01-B/2021-05-21, BoschRexrothAG
Installation | A2FO series 70 31/52
7�4�7 Completion of assembly
1� Remove any installed transport screws.
CAUTION! Operation with protective plugs!
Operating the axial piston unit with protective plugs may result in injury or damage
to the axial piston unit.
▶ Before commissioning, remove all protective plugs and replace them with suitable,
pressure-resistant, metal threaded plugs or connect the appropriate lines.
2� Remove the transport protection.
The axial piston unit comes with protective covers(1) and protective plugs(2).
(1) and (2) are not pressure-resistant and have to be removed prior to
connection. Use asuitabletool for this to prevent damage to the sealing and
functional surfaces. If sealing or functional surfaces are damaged, contact your
BoschRexroth service partner or the service department of the manufacturer's
plant of the axial piston unit.
2
1
Fig� 10: Removing transport protection
1 Protective covers
2 Protective plugs/threaded plugs
Ports intended for connecting lines come with protective plugs and/or threaded
plugs, which serve as transport protection. Make sure all ports required for
functional operation are connected (see Table 10 "Ports A2FO series 70"
onpage34). Failure to do so could lead to malfunctions or damage. If aport
is not being used, plug it with athreaded plug since the protective plugs are not
pressure-resistant.

Bosch rexroth A2FO Series Specifications

General

Brand	Bosch
Model	rexroth A2FO Series
Category	Water Pump
Language	English