Bosch rexroth A2FO Series User Manual

BoschRexrothAG, RE91405-01-B/2021-05-21
8/52 A2FO series 70 | Safety instructions
2 Safety instructions
2�1 About this chapter
The axial piston unit has been manufactured to generally accepted engineering
standards. There is still, however, arisk of personal injury or property damage if this
chapter and the safety instructions in this documentation are not observed.
▶ Read this documentation completely and thoroughly before working with the
axial piston unit.
▶ Keep this documentation in alocation where it is accessible to all users at
all times.
▶ Always include the required documentation when you pass the axial piston unit
on to third parties.
2�2 Intended use
Axial piston units are hydraulic components, meaning that in their application
area they are classified neither as complete nor as partly completed machinery as
defined in the EC Machinery Directive 2006/42/EC. The component is exclusively
intended to form partly completed machinery or complete machinery together with
other components. The component should only be commissioned after it has been
installed in the machine/system for which it is intended, and the safety of the entire
system has been established in accordance with the Machinery Directive.
This product is intended for the following use:
The axial piston unit is only approved as apump for hydrostatic drives in an
open circuit.
▶ Observe the technical data, the application and operating conditions and
the performance limits as specified in the datasheet 91405 and in the order
confirmation. Information about approved hydraulic fluids can be found in
datasheet 91405.
The axial piston unit is only intended for commercial use and not for private use.
Intended use includes having fully read and understood this documentation,
especially chapter 2 "Safety instructions" on page 8.
2�3 Improper use
Any use other than that described as intended use is considered improper.
BoschRexrothAG is not liable for damages resulting from improper use. The user is
solely responsible for any risks arising from improper use.
The following foreseeable forms of faulty usage are also considered improper
(this list is not exhaustive):
• Use outside the operating parameters approved in the datasheet and in the order
confirmation (unless specifically approved by the customer)
• Use of non-approved fluids, e.g.water or polyurethane components
• Changes to factory settings by unauthorized persons.
• Use of assembled parts (e.g. control unit, valves) not in combination with the
specified Rexroth components
• Use of the axial piston unit with assembled parts under water at adepth of more
than10 meters without the necessary additional measures, e.g.pressure equalization.
Units with electrical components (e.g.sensors) must not get into contact with
water, depending on the IP protection class. Observe the IP protection class in the
datasheet 91405.

Bosch rexroth A2FO Series Specifications

General

Brand	Bosch
Model	rexroth A2FO Series
Category	Water Pump
Language	English