Bosch Rexroth CKL Series - Configure Network Connection

Bosch Rexroth Corp., USL00010, 01.2015
5.1.1 Stepsforconguringthenetworkconnection(continued)
4. Enter a unique IP address for the PC (must be dierent than the IndraDrive, see
below note), then click inside the Subnet mask eld, the Subnet mask will default to
255.255.255.0.
5. Open IndraWorks Ds.
6. Enter the IP address of the IndraDrive, the default factory setting is 192.168.0.1.
7. Press the Browse button.
8. The connected IndraDrive appears with device information.
9. Press the OK button.
NOTE: If the IP address of the IndraDrive is 192.168.0.1, then the PC’s rst three dot-decimal
numbers must be the same (for example, 192.168.0.x). The fourth number (x) must be
dierent from that of the IndraDrive’s IP address, and be a number between 0 to 255.
10 Network Connection