2.12 (4 knob) Spreader + 3Boom Anti-icing + Cross Conveyor
The 4 knobs (leftright) are for Spinner, Conveyor, Prewet and Anti-ice. The Up/Down arrows at the
top left are for cross conveyor speed control. It has 4 external switches built in the armrest or a separate
enclosure to switch booms On/Off and switch cross conveyor direction. When a boom is ON the color of the
boom indication letter changes to RED.
3 Selecting Profiles
Profiles allow the system to be configured in different ways. For example, you may have a profile for
standard spreading operation, and another for anti-icing only. To select profiles, press and hold down in the
truck information panel. If profiles are available, the menu shown below will pop up. Select a profile and
then press “Apply Profile”.
Note: You will need to reboot the system 2 times for changes to take effect.
6 Joystick Operation
Available only when equipped with a joystick Armrest Console. When the Deadman Trigger is
pressed, the joystick screen will be shown. When the trigger is released, the screen reverts back to the
spreader layout. The PAUSE, BLAST and Power Float(PFloat, PFloat2) functions on joystick buttons can
always be activated by pressing the button without pressing the Deadman trigger.
Note: The joystick will only operate while the Deadman Trigger is pulled. The default spreader or joystick screen
is selectable on USER setup screen.
To Next Page
Loading...
