Bosch Rexroth CS660 - Troubleshooting Error Messages

13/13
Bosch Rexroth Canada I December 2020 ı Revision 2.0
8 Error Messages
Error Messages
#
Suggested Solution
ERROR BLAST TOO LONG
1
Turn off blast, reset timer
ERROR DEICE BLST TOO LONG
2
Turn off blast, reset timer
ERROR OVERSPEED
3
Slow down, reset max speed
ERROR SPIN PROP
4
Check cables, replace coil
ERROR CONV PROP
5
Check cables, replace coil
ERROR CROSS1 PROP
6
Check cables, replace coil
ERROR CROSS2 PROP
7
Check cables, replace coil
ERROR NO MATL DETECT
8
Load material, check sensor
ERROR NO LIQ DETECT
9
Load material, check sensor
ERROR NO GROUNDSPEED
10
Check cable/sensor
ERROR NO CONVEYOR
11
Check cable/sensor
ERROR NO LIQUID
12
Check cable/sensor
ERROR NO DEICE
13
Check cable/sensor
Warning Messages
#
Suggested Solution
BB3 SYSTEM ERROR
22
Check if RCE present, Reboot
RC COMMUNICATION ERROR
23
Comm failure between display and RC
BOOMS CLOSED
24
Need at least one boom to work
JOY 1 COMMUNICATION ERROR
25
Comm failure between RC and Joy 1
JOY 2 COMMUNICATION ERROR
26
Comm failure between RC and Joy 2
NO GATE SENSOR
27
Check gate sensor, cable break
GATE POSITION ZERO
28
Gate closed in READBACK mode
NO GROUND SPEED SIMULATION
29
Speed Simulation mode stopped
UNDER APPLICATION-SPINNER
30
Spinner not able to reach desired RPM
UNDER APPLICATION-CONVEYOR
31
Rate or spd too hi, incorrect calib
UNDER APPLICATION-PREWET
32
Rate or spd too hi, incorrect calib
UNDER APPLICATION-ANTI-ICING
33
Rate or spd too hi, incorrect calib
CALIB:GND SPD PULSES TOO LOW
37
Too few or no pulses, recalibrate
SPINNER MAX RPM TOO LOW
38
Bad or no sensor
CONVEYOR MAX RPM TOO LOW
39
Bad or no sensor
PREWET MAX HZ TOO LOW
40
Too few pulses, or sensor failed
ANTI_ICING MAX HZ TOO LOW
41
Too few pulses, or sensor failed
WRONG SPINNER CONTROL MODE
42
Auto null not allowed for MAN mode
WRONG PREWET CONTROL MODE
44
Auto-null or calibration not allowed
WRONG ANTI-ICING CTRL MODE
45
Check Anti-icing or CrsCnv modes
WRONG CROSS-CONVEYOR MODE
46
Check Cross-Conv mode setting
WT/REV TOO LOW
47
Check conv sensor, recalibrate
WT/REV TOO HIGH
48
Check conv sensor, recalibrate
PREWET PULSES/GAL TOO LOW
49
Check prewet sensor, recalibrate
PREWET PULSES/GAL TOO HIGH
50
Check prewet sensor, recalibrate
ANTI-ICING PULSES/GAL TOO LOW
51
Check anti-icing sensor,re calibrate
ANTI-ICING PULSES/GAL TOO HIGH
52
Check anti-icing sensor, recalibrate
SPNR WIDTH AT 0 RPM TOO LOW
53
Check spinner sensor, recalibrate
SPNR WIDTH PER RPM TOO LOW
54
Check max width, and recalibrate
GATE MOVEMENT TOO LOW
55
Calibration gate move too low
GATE AT CALIBRATION TOO LOW
57
Calib gate needs to be non-zero
SPN SENSOR PULSES TOO LOW
58
Spin sensor pulses 0 or too low
CONV SENSOR PULSES TOO LOW
59
Conv sensor pulses 0 or too low