[1]
Status/Totals– Display real time status and trip summary. Press&hold icon for 5 seconds to clear.
Vehicle stopped Vehicle in motion
[2]
Settings– Switch to program mode ( a PGM key required)
[3]
Speed– Displays current ground speed. You can simulate ground speed by pressing and holding in the
circle for 5 seconds. The following arrows will appear which will allow you to adjust the speed:
[4]
Toolbox–This button changes depending whether a Program key is inserted into the display or not. When
not inserted, the icon is displayed. Pressing this icon will show the following:
When a Log or Program key are inserted you will see the icon instead. Please see the Parameter
and Log transfer section in this manual for more information. This button also displays the gps/avl
status if gps or avl connection is active.
[5]
Driver ID– This shows the current Driver ID, and allows the selection and naming of Driver IDs. To
select one of four Driver IDs, press on the Driver name and a list will drop down.
To Next Page
Loading...
