ctrlX SAFETY "SafeMotion"
3 Important directions on use
3.1 Intended use
3.1.1
Introduction
The products of Rexroth are developed and manufactured to the state-of-the-
art. Prior to delivery, the products are checked for their fail-safe state.
WARNING
Personal injury and property damage due to incorrect
use of the products!
The products have been designed for use in an industrial
environment and may only be used as intended. If the
products are not used as intended, this may lead to sit-
uations resulting in property damage and personal injury.
NOTICE
Damages resulting from unintended use
The user shall solely bear the risks for damages arising of
unintended use of the products; Rexroth as manufacturer
shall not assume any warranty, liability or compensation
for damages.
Before using Rexroth products, make sure that all the prerequisites for an
intended use of the products are satisfied:
● Anyone that in any way, shape or form uses our products must have read
and understood the relevant safety instructions and the intended use.
● Do not change the original state of the hardware products, i.e., do not make
any structural modifications. Software products must not be decompiled
and their source codes must not be modified.
●
Damaged or defective products must not be installed or commissioned.
●
It has to be ensured that the products are installed according to the provi-
sions specified in the documentation.
3.1.2
Areas of use and application
Antriebsregelgeräte by Rexroth are designed to control electric motors and
monitor their operation. Controlling and monitoring the Antriebsregelgeräte
may require additional sensors and actuators.
The Antriebsregelgeräte may only be used with the accessories and attach-
ments specified in this documentation. Components that are not expressly
mentioned may neither be attached nor connected. The same applies to cables
and lines.
Operation is only allowed in the specified configurations and combinations of
the components using the software and firmware as specified in the relevant
functional descriptions.
Antriebsregelgeräte have to be programmed before commissioning to ensure
that the motor executes the functions specific to the application.
Antriebsregelgeräte of the ctrlX DRIVE series have been developed for use in
single-axis and multi-axis drive and control tasks.
Device types with different drive power and interfaces are available for using
the Antriebsregelgeräte in specific applications.
Typical applications include, for example:
● Handling and assembly systems
● Packaging and food machines
●
Printing and paper converting machines
●
Machine tools
Important directions on use
To Next Page
Loading...
