ctrlX SAFETY "SafeMotion"
input signals from the predefined configuration for a network. The IO mapper
can then be freely defined for this network. The figure below shows, in sche-
matic form, the signal sequence of the "IO mapper inputs":
Fig. 52: IO mapper inputs
1)
Only takes effect with active Safety bus communication
The IO mapper blocks are called and configured via dialogs in ctrlX DRIVE
Engineering (see ⮫ Commissioning).
Depending on the selected IO mapper block type, a circuit diagram of the IO
mapper block is displayed in the corresponding dialog of the network.
To Next Page
Loading...
