ctrlX SAFETY "SafeMotion"
Fig. 71: Parameter verification
After the axis identifier was verified, the identification of the axis can be car-
ried out. After the “Identify SafeMotion” button was clicked, the diagnostic
LEDs PF40 and PF41 at the “SafeMotion” option are flashing at the connected
drive for which the axis identifier is set, with the flashing pattern “red - green -
green - red”. In addition, the display of the control panel shows the Confirm
SMO axis identifier:... message.
Fig. 72: Dialog for applying the axis identifier
The axis identifier has to be confirmed by pressing the [Enter] key at the
panel or by clicking the “Apply axis identifier” button in the dialog provided for
applying the axis identifier.
By pressing the [ESC] key at the panel or by clicking the “Cancel” button, the
assignment of the axis identifier can be aborted.
For devices without panel, the axis identifier can only be confirmed using the
“Apply axis identifier” button in the corresponding dialog.
To Next Page
Loading...
