ctrlX SAFETY "SafeMotion"
Fig. 108: Machine acceptance test: Selection
In this dialog, the processing of the safe and functional input signals at the
"IO mapper inputs" can be checked. For this purpose, it is necessary to check
whether the output signals of the network are switching as intended. If net-
works that have more than one input signal have been activated, the complete
provided input signal combinations should be checked to make sure that there
is no inadmissible input-output combination for the machine.
Via the drop down list "Check network", select the network to be checked.
After the selection was made, the circuit diagram of the function block is
displayed. The assigned signals are provided with check boxes displaying the
current states of the corresponding bit signals. The logic signal names of inputs
and outputs are displayed as tooltips. Via the “Confirm the check” button, the
currently displayed input-output combination will be marked as "OK" on the
memo. If no memo exists at this point, the memo is created.
The name of the memo is generated from the axis identifier. When the memo
is created, the user can choose the directory in which the memos are to be
saved. The default directory for memos is the "My Documents" directory of the
logged-on user. This directory is also used for further memos. The active axis
To Next Page
Loading...
