Bosch Rexroth Hagglunds CBm - Page 50

50/72 Installation
Bosch Rexroth AB, RE 15300-WA, Version 06.2021
Mounting proposal
1. Place the motor with the splines opening upwards.
2. Mount the coupling adapter into the motor.
3. Place the shrink disc on the adapter shaft.
4. Mount the axial locking ring on the end of the
adapter shaft, 12 pcs M16x50 8.8 Mv 197 Nm.
5. Demount the G1/4˝ plug at shaft side of the motor
(venting). Demount the G1/4˝ plug at the back of
the motor (lling) and connect the oil lling pump.
Start lling splines oil until it‘s pouring out from
the plug at shaft side and then mount the G1/4˝
plug. Disconnect the oil lling pump and mount the
G1/4˝ oil lling plug.
6. Ensure that the full clamping length is used by, for
example, measuring and marking the driven shaft.
This is of particular importance if the driven shaft
has a stress relieving groove. See Fig. 42, Fig. 43
and Table 15.
7. Lift/hoist the motor with the adapter shaft up on
the driven shaft to the marked and correct position.
Tightening the shrink disc according to : Tightening
of shrink disc page 44
G¼" plug for degasing of air when filling spline oil
Motor CBM with through hole kit
G¼" plug for filling of spline oil
Axial locking ring
Cover
M16x50 8.8 Mv 197Nm
Adapter shaft
AS XXXX B 1 006
Lifting eyes, not included in delivery
Fig. 50: Vertical mounting of coupling motor (only for CBm 2000 and CBm 3000)
DD00083961
Fig. 51: Vertical mounting of motor with special index coupling adapter AS XXXX B 1 006
Gap 2 mm(0,079 in)
DD00094067