1 Battery box housing
2 Battery box housing cover
3 Battery box housing screw (self-shaping screw 30×10; tightening torque
0.8 Nm)
4 Dispose of exhausted battery
5 Replacement battery from SUP-E03-DKC*CS-BATTRY
6 Refresh resistor from SUP-E03-DKC*CS-BATTRY
Fig.7-7: Battery Box
How to replace the battery
1. Loosen housing screws (3) of battery box (1) and remove cover (2) of
battery box
2. Remove old battery (4)
3. Carry out "refresh" procedure for new battery (5): Connect battery for 2
minutes to refresh resistor
4. Insert new battery (5) into battery compartment
5. Connect connector of battery to mating connector in battery compartment
6. Put cover (2) of battery box (1) onto housing and screw down housing
screws (3) with 0.8 Nm
7. Dispose of old battery (4) according to directives valid in your country
Instruction Manual | Rexroth IndraDrive Electric Drives
and Controls
| Bosch Rexroth AG 53/65
Accessories
To Next Page
Loading...
