Fig.8-24: Entering the axis jerk
After having restarted the NC, restart the NC program with the changed
"JKC(<axis name>1)" NC command. While traversing the axis, you can observe
that the jerk occurring when the velocity is changed has now been reduced. In
the example below, the X-axis is moved in the following NC program.
Example for the x-axis
Fig.8-25: NC program with activated axis jerk limitation
Optimization of the axis is now completed. The operation must be
repeated for the other axes and spindles.
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
108/141
Commissioning the Drives
To Next Page
Loading...
