Bosch Rexroth IndraMotion MTX micro - Assigning the Axes to the Drives

7.3.2 Assigning the Axes to the Drives
The system axes
are assigned to the drives of the HCQ02 and HCT02 drive
controllers by assigning the SERCOS address in the NC configuration. The
SERCOS addresses are permanently assigned to the drives. The assignments
are shown in the following figure.
Fig.7-11: Relation between drive, connection and SERCOS address
The following axis configurations are defined in the basic projects:
Fig.7-12: Axis configurations of default projects
DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
Bosch Rexroth AG 83/141
NC Parameterization