Fig.7-13: Parameter axis assignment
The axis is assigned to a specific connection by changing the SERCOS address
(MAIN/Dr[i]/Scs/ScsAddr).
Parameters for linear axes
Now set the travel range limits, the velocity and the acceleration.
Relations are shown in the following figures:
Fig.7-14: Schematic diagram 1
Fig.7-15: Schematic diagram 2
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
84/141
NC Parameterization
To Next Page
Loading...
