T: Direct grounding of a point (signal ground)
N: Body directly connected to the signal ground
C: Functions of neutral and protective conductors in the entire network
combined in a single conductor, i.e., the PEN conductor
Fig.4-10: TN-C network type
We strongly recommend that you connect the devices to TN net‐
works. Please contact
us if you prefer connection of the devices to
a TT network, an IT network or a network with grounded outer con‐
ductor.
For more information about this subject, please refer to the project
planning instructions on IndraDrive
(DOK-INDRV*-SYSTEM*****-PR04-EN-P).
DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
Bosch Rexroth AG 33/141
Selecting and Connecting the Hardware
To Next Page
Loading...
