The number of the message (1–2048) defines the reaction of the CNC to this
message.
Fig.6-12: MTX micro-c message classes
Message numbers 1 to 400 are reserved to the system PLC pro‐
gram and may not be programmed!
Active message classes are determined by the "MTXmicro_Diag" function block
in the prDiag PLC program. A global flag is output for each message class.
Fig.6-13: prDiag with MTXmicro_DIAG function block
DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
Bosch Rexroth AG 71/141
PLC Startup
To Next Page
Loading...
