Bosch Rexroth IndraMotion MTX micro - Basic configuration

You can now load the basic parameter block of the drive.
To do this, proceed as follows in IndraWorks Engineering:
1. Set the focus
on the "IndraMotion_MTX_micro_c" node of the Project Ex‐
plorer, double-click and select "Show Online" from the context menu that
appears.
2. If the HCQ (or HCT) drive is shown on a blue or red background, the drives
are switched to online mode.
3. Set the focus on the node of an axis of the Project Explorer,e.g. "Ax‐
is[X]", right-click and select "ParametersLoad Basic Parameters…"
from the context menu that appears.
4. Click on "Carry out" to load the basic parameters.
5. After "Load Basic Parameters" has been completed successfully, click on
"Close" to finish the process.
Fig.8-3: Loading basic parameters
● Steps 3, 4, 5 are required for each axis.
● Please wait for approx. 1 minute before loading the basic pa‐
rameters of the next axis.
● After
the basic parameters have been loaded for all axes, the
machine must be turned off and on again.
DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
Bosch Rexroth AG 91/141
Commissioning the Drives